Component Inspection

1. Turn ignition switch OFF.
2. Disconnect 4WD switch assembly harness connector.
3. Check the continuity between 4WD switch assembly terminals under the following conditions.

   Terminals	Condition		Continuity
   12 and 22	Snow Mode switch	ON	Existed
   		OFF	Not Existed

Is the inspection result normal?

YES>>

INSPECTION END

NO>>

Replace 4WD switch assembly. Refer to CENTER CONSOLE ASSEMBLY : Removal and Installation .

1. Turn ignition switch OFF.
2. Disconnect snow Mode/tow Mode/VDC OFF switch assembly harness connector.
3. Check the continuity between snow Mode/tow Mode/VDC OFF switch assembly terminals under the following conditions.

   Terminals	Condition		Continuity
   12 and 22	Snow Mode switch	ON	Existed
   		OFF	Not Existed

Is the inspection result normal?

YES>>

INSPECTION END

NO>>

Replace snow Mode/tow/Mode/VDC OFF switch assembly. Refer to CENTER CONSOLE ASSEMBLY : Removal and Installation .