FixVault
Home › Nissan-Datsun › 2024 › Leaf SV Plus › Repair and Diagnosis › Hybrid/Electric Powertrain › Electric Converters and Controllers › EV Control System › Component/Circuit Diagnosis › Battery Current Sensor › Component Function Check

Component Function Check

  1. PRECONDITIONING 
    • Before performing the following procedure, confirm that battery voltage is more than 12.8 V while power switch ON.
    • Before performing the following procedure, confirm that all load switches and A/C switch are turned OFF.

    >>

    GO TO 2

  2. PERFORM COMPONENT FUNCTION CHECK 
    1. Turn power switch ON.
    2. Check the voltage between VCM harness connector terminals.
      VCM Voltage
      Connector + -
      Terminal Terminal
      E62 84 (Battery current sensor signal) 149 Above 2.37 V at least once

    Is the inspection result normal?

    YES>>

    INSPECTION END

    NO>>

    Refer to DTC Diagnosis Procedure .

About FixVault