Work Procedure

WARNING: This page is about a different car, the 2023 Nissan Sentra. However, it is still accessible from the selected car via links, so may be relevant.

Perform action test to verify the customer's concern.
Perform action test and check the system operation after system diagnosis.

Warning:

WARNING: Be careful of traffic conditions and safety around the vehicle when performing road test.

CAUTION:

Fully understand the following items well before the road test;
- System description for RCTA: Refer to System Description .
- Handling precaution: Refer to Precautions for Rear Cross Traffic Alert .

CHECK BSW/RCTA SYSTEM SETTING
1. 1. Start the engine.
  2. After start the engine wait for 30 seconds or more.
  3. Enable the setting of the BSW system on the information display.
  4. Turn OFF the ignition switch and wait for 5 seconds or more.
  5. Check that the previous setting is saved when the engine starts again.
>>

GO TO 2.

ACTION TEST FOR RCTA

Enable the setting of the BSW system on the information display.

Check the RCTA operation according to the following table.

Condition				Action	Indication on the BSW indicator	Display on information display	Buzzer
RCTA OFF				-	OFF	-	OFF
RCTA ON	Shift lever is in any position other than reverse			-	OFF	-	OFF
	Shift lever is in reverse	Vehicle speed is less then approx. 8 km/h (5 MPH)	Vehicle is not detected	-	OFF	-	OFF
		Vehicle speed is less then approx. 8 km/h (5 MPH)	Vehicle is detected	-	Blink	-	Single beep
		Vehicle speed is approx. 8 km/h (5 MPH) or more	Vehicle is detected	-	-	-	-

INSPECTION END