Choke Unloader
NOTE:
Choke coil lever and choke rod (fast idle cam) adjustments must be correct before performing this adjustment.
- Install rubber band to vacuum break lever of intermediate choke shaft. Open throttle, allowing choke valve to close. Install Angle Gauge (J-26701-A) on choke valve. See Fig 1 .
- Adjust angle gauge to specification. See CARBURETOR ADJUSTMENT SPECIFICATIONS table. Hold secondary lock-out lever away from pin. See Fig 1 .
- Hold throttle lever in wide open position. Note bubble on angle gauge. Adjustment is correct when angle gauge bubble is centered. Using Linkage Adjuster (J-9789-111), adjust fast idle lever to center bubble.