FixVault
Home › Oldsmobile › 1994 › Achieva SC, 2.3 D › Repair and Diagnosis › Body & Frame › Door Locks › Keyless Entry System - Remote › Testing › Remote Keyless Entry & Illuminated Entry › Both Transmitters Do Not Operate Some Or All Features

Both Transmitters Do Not Operate Some Or All Features

  1. Disconnect RKE module connector C1. Ensure continuity is present between connector terminal "F" (Black/White wire) and program connector terminal "A" (Black/White wire). If continuity is to specification, go to next step. If continuity is not to specification, check Black/White wire for an open circuit.
  2. Turn ignition switch to RUN position. Check for battery voltage at module connector C1 terminal "B" (Pink wire). If battery voltage is present, reconnect connector and go to next step. If battery voltage is not present, check for open circuit or short to ground in Pink wire.
  3. Disconnect RKE module connector C2. If battery voltage is present at connector terminal "A" (Orange wire), go to next step. If battery voltage is not present, check Orange wire for an open circuit.
  4. Ensure RKE module connector C2 is still disconnected. Connect jumper wire between module connector C2 terminal "B" (Black wire) and voltage. If trunk lid release solenoid activates, go to next step. If trunk lid release solenoid does not activate, check Black wire for an open circuit.
  5. Ensure RKE module connector C2 is still disconnected. Connect jumper wire between module connector C2 terminal "C" (Tan wire). If driver's door unlocks, go to next step. If driver's door does not unlock, check Tan wire and Gray wire at door lock motor for an open circuit.
  6. Ensure RKE module connector C2 is still disconnected. Hold either door lock switch in unlock position. If battery voltage is present at module connector C2 terminal "D" (White wire), go to next step. If battery voltage is not present, check White wire for an open circuit.
  7. Ensure RKE module connector C2 is still disconnected. Hold either door lock switch in lock position. If battery voltage is present at module connector C2 terminal "E" (Light Blue wire), go to next step. If battery voltage is not present, check Light Blue wire for an open circuit.
  8. Ensure RKE module connector C2 is still disconnected. If battery voltage is present at module connector C2 terminal "F" (White wire), go to next step. If battery voltage is not present, check White wire for an open circuit.
  9. Put transmission in Park or Neutral. With RKE module connector C2 still disconnected, ensure continuity is present between terminal "G" (White/Black wire) and ground. If continuity is not present, check White/Black wire for an open circuit or short to voltage. If all checks are to specification, replace RKE module.
  10. Ensure RKE module connector C2 is still disconnected. Ensure continuity is present between module connector C2 terminal "H" (Black wire) and ground. If continuity is not present, check Black wire for an open circuit. If battery voltage is present, replace RKE module.
About FixVault