Trouble Shooting
- Check IPC/BFC ACC fuse (10-amp) and IPC/HVAC BATT fuse (10-amp) located in left instrument panel wiring harness junction block. Using scan tool, check for Diagnostic Trouble Codes (DTCs). If any BFC DTCs exist, see BODY CONTROL MODULE
article. If any PCM DTCs exist, see appropriate TESTS W/CODES
article in ENGINE PERFORMANCE section:
- If turn signal indicator(s) is inoperative, locate and repair problem in exterior lighting system. See WIRING DIAGRAMS
. If instrument panel illumination lights are inoperative, locate and repair problem in interior lighting system. See WIRING DIAGRAMS
. If SERVICE ENGINE SOON indicator is illuminated, diagnose and repair problem in PCM system. See appropriate TESTS W/CODES
article in ENGINE PERFORMANCE section:
- If air bag indicator is illuminated continuously with no loss of serial data, use scan tool to monitor Sensing and Diagnosis Module (SDM). If SDM is commanding air bag indicator on, locate and repair problem in air bag system. See AIR BAG RESTRAINT SYSTEM article. If SDM is not commanding air bag indicator on, replace instrument cluster.
- Check for loss of serial data communications between BFC and instrument cluster. See BODY CONTROL MODULE
article. For further diagnosis of instrument cluster indicators and gauges, see procedures in BODY CONTROL MODULE
article.
- Check for broken (or partially broken) wire inside of insulation which could cause system failure but pass a continuity/voltage check. Check for proper installation of aftermarket equipment.