FixVault
Home › Oldsmobile › 1998 › Eighty-Eight Base › Repair and Diagnosis › Engine Performance › Remove, Overhaul & Install › Engine Controls - Remove/Install/Overhaul 3.8L › Ignition System › Ignition Control Module (C(3)I) › Removal & Installation

Removal & Installation

  1. Disconnect negative battery cable. Disconnect 14-way connector at ignition control module. Disconnect spark plug wires from coil pack. Remove 6 screws retaining coils to ignition control module. Remove ignition coils from module.
  2. Remove screws and washers securing ignition control module to bracket. Remove ignition control module. To install, reverse removal procedure. Tighten retaining screws to specification. See TORQUE SPECIFICATIONS .
About FixVault