FixVault
Home › Oldsmobile › 2000 › Intrigue GL › Repair and Diagnosis › Steering › Steering Wheel And Steering Column - Tilt › Repair Instructions › Steering Wheel Control Switch Assembly Replacement › Installation Procedure

Installation Procedure

Fig 1: View Of Electrical Connector And Steering Wheel Control Switch
GM652099Courtesy of GENERAL MOTORS CORP.
  1. Connect the electrical connector to the steering wheel control switch.
  2. Position the steering wheel control switch to the steering wheel.
    NOTE: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
    Fig 2: Removing/Installing Steering Wheel Control Switch
    GM652097Courtesy of GENERAL MOTORS CORP.
  3. Install the screws to the steering wheel control switch.

    Tighten 

    Tighten the steering wheel control switch screws to 2 N.m (19 lb in).

  4. Inspect the operation of the steering wheel control switch.
  5. Install the inflatable restraint steering wheel module. Refer to INFLATABLE RESTRAINT STEERING WHEEL MODULE in S.I.R.
  6. Enable the S.I.R. system. Refer to ACTIVATING SYSTEM in S.I.R.
About FixVault