FixVault
Home › Oldsmobile › 2000 › Intrigue GL › Repair and Diagnosis › Transmission › Automatic Trans › Automatic Transmission Servicing › Removal & Installation › Case Extension Housing › Installation

Case Extension Housing: Installation

  1. If removed install the drive axle seal. See Figure . Install the case extension housing with the axle seal and the O-ring.
  2. Install the case extension housing bolts. Tighten the case extension housing bolts to specification. See TORQUE SPECIFICATIONS  . Install the vehicle speed sensor. See VEHICLE SPEED SENSOR  .
  3. Install the transaxle brace to engine bolts. See TRANSAXLE BRACE  . Install the right (rear) engine mount bracket. Install the right (rear) engine mount. Install the right drive axle to the transaxle. See appropriate article in DRIVE AXLES. Lower the vehicle.
    4. CAUTION: Do not overfill the transaxle. Overfilling of the transaxle causes foaming, loss of fluid, shift complaints, and possible damage to the transaxle.
  4. Connect the negative battery cable. Fill transaxle with appropriate fluid to proper level. See LUBRICATION  . Inspect for fluid leaks.
About FixVault