FixVault
Home › Oldsmobile › 2002 › Aurora 3.5 H › Repair and Diagnosis › Suspension › Electronic Suspension System - Automatic Level Control › Repair Instructions › Automatic Level Control Air Compressor Head Replacement › Assembly Procedure

Assembly Procedure

  1. Install the new gasket on the air compressor.
  2. Install the air compressor head on the air compressor with the 3 bolts.

    Tighten 

    Tighten the bolts to 6 N.m (53 in lbs).

  3. Connect the air hose.
  4. Install the 2 wire terminals in the air compressor connector.
    Fig 1: Installing Air Compressor Head
    G01582140Courtesy of GENERAL MOTORS CORP.
  5. Install the wrap around 4 wires and secure with 2 harness ties.
  6. Install the wiring harness and the harness clamp on the air compressor head with the bolt.

    Tighten 

    Tighten the bolt to 3 N.m (26 in lbs).

  7. Install the air dryer. Refer to Automatic Level Control Air Dryer Replacement .
    Fig 2: Installing Wiring Harness & Harness Clamp
    G01582141Courtesy of GENERAL MOTORS CORP.
  8. Install the heat shield with the 2 bolts.

    Tighten 

    Tighten the bolts to 4 N.m (35 in lbs).

  9. Connect the air compressor connector to the connector anchor.
  10. Install the air compressor on the vehicle. Refer to Air Compressor Replacement .
    Fig 3: Installing Heat Shield & Bolts
    G01582142Courtesy of GENERAL MOTORS CORP.
About FixVault