FixVault
Home › Oldsmobile › 2002 › Bravada AWD › Repair and Diagnosis › Transmission › Automatic Trans › Automatic Transmission Servicing › Removal & Installation › 2-4 Servo › Installation

2-4 Servo: Installation

  1. Install the new seals on the pistons and the servo cover. Lubricate the seals with clean transmission fluid. Install the 2-4 servo assembly into the 2-4 servo bore. Install the servo cover and O-ring seal. Install the servo cover depressor.
  2. Tighten the bolt on the servo cover depressor to compress the servo cover. See Figure . Install the servo cover retaining ring. Remove the servo cover depressor from the oil pan flange.
  3. Install the oil pan bolt. Tighten the oil pan bolt to specification. See TORQUE SPECIFICATIONS  .
  4. Install the heat shield. Install the 2 bolts securing the transmission heat shield to the transmission. Tighten the heat shield bolts to specification. See TORQUE SPECIFICATIONS  .
  5. Install the exhaust pipe assembly. Install the transmission support. Remove the transmission jack. Lower the vehicle. Fill transmission with appropriate fluid to proper level. See LUBRICATION  .
About FixVault