Shift Cable: Removal
- Ensure the vehicle is in the Park position. Raise and support the vehicle. Remove the end of the range selector cable from the transmission range selector lever ball stud (6). See Figure
.
- Remove the retainer (5) from the range selector cable. Remove the range selector cable (4) from the bracket (1). Remove the cable from the retainer (3) on the floor panel.
- If the vehicle is equipped with 4WD, remove the cable from the retainers located on the transfer case. Remove the drivers side front mat and carpet. Push the cable grommet (2) up through the floor panel. See Fig 1
. Lower the vehicle.
- Remove the console. See appropriate SHIFT INTERLOCK SYSTEMS article in AUTOMATIC TRANSMISSIONS. Remove the end of the range selector cable (1) from the floor control ball stud. See Fig 2
.
- Remove the range selector cable (2) from the floor shift control assembly. Remove the tape and grommet on the shift cable from the floor panel. Remove the range selector cable (3) from the vehicle.
Courtesy of GENERAL MOTORS CORP.
Courtesy of GENERAL MOTORS CORP.