FixVault
Home › Oldsmobile › 2002 › Intrigue GL › Repair and Diagnosis › Transmission › Automatic Trans › Automatic Transmission Removal & Installation › Removal & Installation › Frame Replacement › Installation

Frame Replacement: Installation

  1. If you are replacing the frame, install the following components:
    • Both of the lower control arms.
    • The stabilizer shaft.
    • The spacers, the upper insulator, the lower insulator, and the retainers.
  2. Position the engine support table with the frame under the vehicle.
  3. Lower the vehicle to the frame.
  4. Loosely install the NEW bolts to secure the rear frame to the body. See Figure .
  5. Loosely install the NEW bolts to secure the front frame to the body. See Figure .
  6. Align the frame to the body by inserting two 0.74 X 8.0" (19 X 203 mm) pins in the alignment holes on the right side of the frame. Tighten the frame bolts to specification. See TORQUE SPECIFICATIONS  .
  7. Connect both the lower ball joints to the steering knuckle.
  8. Install the nuts which secure the engine mount to the frame.
  9. Install the nuts which secure the transaxle mount to the frame.
  10. Install the steering gear mounting bolts.
  11. Install the stabilizer shaft links.
  12. Connect both front wheel speed sensor connectors (1). See Figure .
  13. Install both front wheel speed harness retainers (2) to the frame and to the lower control arm. See Figure .
  14. Install the positive battery cable and retainers to the frame.
  15. Install the power steering cooler pipe.
  16. Install the radiator lower air deflector.
  17. Connect the fog lamp electrical connectors to the fog lamps.
  18. Install the front tires and wheels.
  19. Lower the vehicle.
  20. Remove the engine support fixture.
  21. Inspect the front wheel alignment. See appropriate SPECIFICATIONS & PROCEDURES article in WHEEL ALIGNMENT.
  22. Center the steering angle sensor. See PROGRAMMING in appropriate ANTI-LOCK/TCS article in BRAKES.
About FixVault