Shift Cable: Removal

Remove the throttle body air inlet duct. Remove the shift cable from the wiring harness clip or strap. Remove the shift cable from the Park/Neutral position switch. See Fig 1 .
Remove the shift cable from the shift cable bracket. See Fig 2 . Remove the front floor console. See appropriate SHIFT INTERLOCK SYSTEMS article.
Pull the carpet back to expose the shift cable. Remove the shift cable retaining clip from the console shift control. See Fig 3 .
Remove the shift cable from the console shift control.
Remove the automatic transaxle range selector cable through the hole in the cowl. See Fig 4 . Remove the automatic transaxle range selector cable from the PNP switch.

Fig 1: Removing & Installing Shift Cable At Park/Neutral Position Switch

Courtesy of GENERAL MOTORS CORP.

Fig 2: Removing & Installing Shift Cable From Bracket

Courtesy of GENERAL MOTORS CORP.

Fig 3: Removing & Installing Shift Cable Retaining Clip

Courtesy of GENERAL MOTORS CORP.

Fig 4: Locating Shift Cable Pass-Through At Firewall

Courtesy of GENERAL MOTORS CORP.