FixVault
Home › Oldsmobile › 2004 › Bravada AWD › Repair and Diagnosis › Body & Frame › Windows › Stationary Window System › Repair Instructions › Windshield Side Reveal Molding Replacement › Installation Procedure

Installation Procedure

  1. Install the windshield side reveal molding under the outer edges of the air inlet grille panel.
    2. Fig 1: View Of Front Door Sealing Weatherstrip
    GM441415Courtesy of GENERAL MOTORS CORP.
  2. Position the windshield side reveal molding (2) to the windshield pillar.
    3. Fig 2: Identifying Windshield Reveal Molding Screws
    GM301107Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Install the screws to the side reveal molding.

    Tighten:  Tighten the screws to the side reveal molding to 2 N.m (18 lb in).

  4. Reposition the front door weatherstrip to the pinch-weld flange.
    5. Fig 3: Removing/Installing Weather-Strip Retainers
    GM588275Courtesy of GENERAL MOTORS CORP.
  5. Install the push-pin retainers (2) to the front door sealing weatherstrip located at the base of the pillar.
  6. Close the door.
About FixVault