Engine Assembly: Remove, Install, and Overhaul
WARNING: This page is about the 505 SW8, 2.2 E, Automatic, which is a different variant/trim than selected.
Includes: Replace Rings, Main and Rod Bearings, Camshaft(s), Crankshaft and Timing Components. Remove Cylinder ridge, burnish Cylinders, grind Valves and clean and test or replace Lifters.
Includes (where applicable): Adjust Valves. DOES NOT include Pin fit or rebore and align Rods. See machine operations.| Applies To | Note | Standard Hours | Warranty Hours | Skill Level |
|---|---|---|---|---|
| In-Line4,Gas,2.2L Eng,Automatic Trans,Normally Aspirated | 30.7 | A | ||
| In-Line4,Gas,2.2L Eng,Turbocharger | 25.9 | A | ||
| Additional Procedure: ENGINE ASSEMBLY: Remove, Install, and Overhaul: | ||||
| Where Intercooler interferes add | 0.7 | A | ||
| Where Pwr Strg interferes add | 0.5 | A | ||