Motor Run Test
- Disconnect motor leads at bulkhead connector. Connect jumper between F2 and ground, and a second jumper between battery positive terminal and A and F1. Insure good ground at motor ground strap. If motor runs continuously, disconnect jumpers.
- If motor does not run and ground is good, disconnect jumpers to battery. Remove drive crank arm from motor and reconnect battery jumpers to A and F1. If motor runs, check linkage for binding.
- If motor still does not run, disconnect battery jumpers and remove switch cover plate and check gear and latch assembly for binding. Pull gear and latch out of gear housing. Touch jumper to battery and if motor runs, replace gear and latch. If motor does not run, replace motor.