"G" Sensor
WARNING: This page does not describe the selected car, but rather 10 other vehicles, including the 1988 Chrysler Conquest, 1987 Chrysler Conquest, 1986 Plymouth Conquest, 1986 Dodge Conquest, and 1985 Plymouth Conquest. However, it is still accessible from the selected car via links, so may be relevant.
- Turn ignition on. Connect a DVOM, between Green wire of "G" sensor and ground. Leave "G" sensor connected to wiring harness. When sensor is level, voltage should be 1.1-1.5 volts. Slowly rotate sensor 90 degrees. Voltage should be 4.6-5.0 volts. If sensor voltage is not to specification, replace "G" sensor.
- Ensure unlaiden vehicle is on a level surface. Using a spirit level, check levelness of sensor vertically and horizontally. Sensor must be within one degree. If sensor varies more than one degree, use shims to adjust within tolerance.