FixVault
Home › Plymouth › 1995 › Acclaim 3.0 3 › Repair and Diagnosis › Engine Performance › System › Engine Controls - Tests W/Codes - 2.5L TBI › Test TC-13C › Injector #1 Control Circuit

Injector #1 Control Circuit

NOTE: For circuit and connector terminal identification, see CONNECTOR IDENTIFICATION. For wiring diagrams, see WIRING DIAGRAMS - 2.5L TBI article in ENGINE PERFORMANCE.
  1. Turn ignition off. Disconnect injector No. 1 connector (White/Dark Blue and Dark Green/Black wires). Using an external ohmmeter, check injector resistance. If resistance is not 2-5 ohms, replace injector No. 1. Perform TEST VER-2.
  2. If resistance is 2-5 ohms, turn ignition on. Using scan tool, actuate injector No. 1. Using scan tool, check voltage on injector No. 1 connector (Dark Green/Black wire). If voltage is less than 10 volts, repair open in Dark Green/Black wire. Perform TEST VER-2.
  3. If voltage is more than 10 volts, turn ignition off. Disconnect Powertrain Control Module (PCM) connector. Using an external ohmmeter, check resistance of White/Dark Blue wire between injector No. 1 connector and PCM connector terminal No. 16. If resistance is more than 5 ohms, repair open in White/Dark Blue wire. Perform TEST VER-2.
  4. If resistance is less than 5 ohms, put scan tool in ohmmeter mode. Using scan tool, check resistance of PCM connector terminal No. 16 (White/Dark Blue wire). If resistance is less than 5 ohms, repair short to ground in White/Dark Blue wire. Perform TEST VER-2. If resistance is more than 5 ohms, replace PCM. Perform TEST VER-2.
About FixVault