Pinion Clearance Check
Connect an electrical source of approximately 6 volts between solenoid "S" terminal and ground.
CAUTION:
Do not use more than 6 volts or motor will operate. As a further precaution, connect a heavy jumper wire from solenoid motor terminal to ground.
After energizing solenoid, push pinion away from stop retainer as far as possible and use feeler gauge to check clearance between pinion and retainer. Clearance should be.010"-.140".
NOTE:
Pinion clearance is not adjustable. If clearance not within specifications, motor must be disassembled and checked for defects.