FixVault
Home › Pontiac › 1992 › LeMans VL › Repair and Diagnosis › Engine Performance › Remove, Overhaul & Install › Engine Controls - Remove/Install/Overhaul › Ignition System › Pick-Up Coil › Removal

Pick-Up Coil: Removal

  1. Remove distributor from engine. See DISTRIBUTOR. Remove roll pin retaining spring from coupling. Mark coupling and shaft for reassembly reference. Support body of coupling in "V" block. DO NOT support on tangs.
    CAUTION: Coupling is under spring tension.
  2. Drive out roll pin and remove coupling. Clean any burrs from shaft and remove shaft. Remove pick-up coil retainer plate, and lift pick-up coil assembly from distributor. See Figure . Disconnect module connectors. Remove module mounting screws and module.
About FixVault