Manual Transmission Clutches: Bleeding

CAUTION: Do not use silicone, mineral or paraffin base oil in clutch hydraulic system, or damage to rubber parts in cylinders may occur.

NOTE: Bleeding is necessary if system has been opened or if air has been drawn into system due to low fluid level in reservoir.

Ensure reservoir is filled with NEW clutch hydraulic fluid. Raise and support vehicle. Attach hose to clutch actuator bleeder, located on left side of transmission. Submerge other end of hose in container of clutch hydraulic fluid. Depress clutch pedal slowly and hold. Loosen bleeder to purge air from system. Tighten bleeder. Repeat bleeding procedure until air is completely purged and no bubbles are visible. Fill reservoir.