FixVault
Home › Pontiac › 2001 › Aztek Base, AWD › Repair and Diagnosis › External Pages › Different car › Section 1067 (Supplemental Inflatable Restraint System) › Repair Instructions › SIR Disabling and Enabling Zone 5 › Enabling Procedure

Enabling Procedure

WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the key from the ignition.
  2. Connect the I/P module connector (1).
  3. Install the CPA (2) from the inflatable restraint I/P module connector (1) located behind the RH insulator panel.
    4. Fig 1: Identifying Inflatable Restraint IP Module Connector
    GM262989Courtesy of GENERAL MOTORS CORP.
  4. Install the RH insulator panel.
    5. Fig 2: Locating SIR Fuse
    GM628316Courtesy of GENERAL MOTORS CORP.
  5. Install the SIR Fuse.
  6. Install the console accessory wiring junction block access hole cover.
  7. Staying well away from all inflator modules and pretensioners, turn ON the ignition.
    1. The AIR BAG indicator will flash 7 times.
    2. The AIR BAG Indicator will then turn OFF.
  8. Perform Diagnostic System Check - SIR  if the AIR BAG indicator does not operate as described.
About FixVault