FixVault
Home › Pontiac › 2001 › Aztek Base, AWD › Repair and Diagnosis › External Pages › Different car › Section 1165 (Lighting Systems) › Repair Instructions › Headlamp Motor/Actuator Replacement › Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2003 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the headlamp motor/actuator to the headlamp assembly.
  2. Install the pivot arm to the motor.

    Place the pivot arm in the position noted prior to removal.

  3. Loosely install the nut retaining the headlamp assembly pivot arm to the motor/actuator.
    NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  4. Install the headlamp motor/actuator bolts.

    Tighten 

    • Tighten the headlamp motor/actuator mounting bolts to 7 N.m (62 lb in).
    • Tighten the headlamp motor/actuator to pivot arm nut to 6 N.m (53 lb in).
  5. Connect the headlamp wiring harness electrical connectors to the headlamp bulbs.
  6. Install the headlamp assembly to the vehicle. Refer to HEADLAMP REPLACEMENT .
    Fig 1: Installing Headlamp Motor/Actuator To Headlamp
    G01453318Courtesy of GENERAL MOTORS CORP.
About FixVault