Removal Procedure

Important:  These procedures are applicable to both of the antenna cables in this vehicle.

1. Remove the radio. Refer to Radio Replacement .
2. Remove the sunshade. Refer to SUNSHADE REPLACEMENT .
3. Remove the sunshade anchor. Refer to SUNSHADE ANCHOR REPLACEMENT .
4. Remove the trim panel from the right cowl side. Refer to TRIM PANEL REPLACEMENT - COWL SIDE .
5. Remove the garnish molding from the windshield. Refer to GARNISH MOLDING REPLACEMENT - WINDSHIELD PILL .
   Fig 1: Removing Antenna Cable Extension Bolt

   Courtesy of GENERAL MOTORS CORP.
6. For the Rendezvous, remove the assist handle from the headliner. Refer to ASSIST HANDLE REPLACEMENT (AZTEK) or ASSIST HANDLE REPLACEMENT (RENDEZVOUS) .
7. Remove the bolt that secures the antenna cable extension to the roof. This bolt is located under the right front corner of the headliner.
8. Remove the antenna cable from the instrument panel carrier.
   Fig 2: View Of Antenna Cable

   Courtesy of GENERAL MOTORS CORP.
9. Remove the following components from the vehicle:
   • The antenna cable
   • The antenna cable extension
   Fig 3: Removing Antenna Cable & Extension

   Courtesy of GENERAL MOTORS CORP.