Removal Procedure
WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2002 GMC Yukon XL, 2002 GMC Yukon, 2002 Chevrolet Tahoe, 2002 Chevrolet Suburban, and 2002 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
- Disconnect the negative battery cable. Refer to BATTERY NEGATIVE CABLE DISCONNECT/CONNECT PROCEDURE (SINGLE BATTERY) or BATTERY NEGATIVE CABLE DISCONNECT/CONNECT PROCEDURE (AUXILIARY BATTERY) .
- Lift up the left outboard cowl vent grille trim piece in order to release the clips to the left outboard cowl vent grille trim piece.
- Remove the hood. Refer to Hood Replacement .
- Remove the left hood spring assembly. Refer to Hood Link Replacement .
- Remove the left fender to cowl support brace.
- Remove the wheelhouse panel bracket.
- Remove the battery tray. Refer to BATTERY TRAY REPLACEMENT .
- Disconnect the hood latch release cable from the clips.
- Disconnect the windshield washer hose from the clips on the fender.
- Remove the underhood electrical center. Refer to UNDERHOOD ELECTRICAL CENTER OR JUNCTION BLOCK REPLACEMENT .
- Remove the push-in retainers (2) in order to detach the wheelhouse panel (1) from the fender (3).
- Remove the fender to upper cowl bracket bolt.
- Open the door.
- Remove the fender to door hinge bolts.
- Release the left front grille clip from the fender.
- Remove the fender to radiator support bolts and retainer.
- Remove the rear lower fender bolt.
- Remove the left fender from the vehicle.