FixVault
Home › Pontiac › 2001 › Aztek Base, AWD › Repair and Diagnosis › External Pages › Different car › Section 1260 (Body Front End) › Repair Instructions › Hood Insulator Replacement › Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2002 GMC Yukon XL, 2002 GMC Yukon, 2002 Chevrolet Tahoe, 2002 Chevrolet Suburban, and 2002 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Open the hood.
  2. Disconnect the underhood lamp harness electrical connector from the lamp assembly.
  3. Remove the lamp harness fasteners from the underhood.
  4. Depress the tab in order to remove the underhood lamp assembly.
    5. Fig 1: Disengaging Push-In Retainers Using J 38778
    GM385754Courtesy of GENERAL MOTORS CORP.
  5. Use theJ 38778  in order to disengage the push-in retainers.
    6. Fig 2: Removing Hood Insulator
    GM385753Courtesy of GENERAL MOTORS CORP.
  6. Gently pull on the hood insulator (1) in the center to slide out from behind the holding tabs (4). The insulator has a crease on the hood side to facilitate folding.
About FixVault