FixVault
Home › Pontiac › 2001 › Aztek Base, AWD › Repair and Diagnosis › External Pages › Different car › Section 1280 (Interior Trim) › Repair Instructions › Carpet Replacement - Front › Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Seat Mounting Component View
    GM71215Courtesy of GENERAL MOTORS CORP.
  1. Remove the seat. Refer to Seat Replacement (Power) or Seat Replacement (Manual) in Seats.
    2. Fig 2: Door Sill Trim Plate
    GM333455Courtesy of GENERAL MOTORS CORP.
  2. Remove the door sill trim plate. Refer to Door Sill Plate Replacement .
    3. Fig 3: Accelerator Pedal Stop Bracket
    GM71197Courtesy of GENERAL MOTORS CORP.
  3. Remove the accelerator pedal stop bracket.
    4. Fig 4: Nut Attaching The Foot Rest To Side Rail & Dash Panel Stud
    GM282004Courtesy of GENERAL MOTORS CORP.
  4. Remove the driver foot rest.
    5. Fig 5: Kick-Up Panel Upper Latches
    GM71195Courtesy of GENERAL MOTORS CORP.
  5. Remove the floor kick-up panel from the passenger side only. Refer to Kick-Up Panel Replacement - Front Floor .
    6. Fig 6: Instrument Panel & Accessory Trim Plate
    GM71207Courtesy of GENERAL MOTORS CORP.
  6. Pull the carpet back and disconnect the air duct from the passenger side only.
  7. Pull the intermediate carpet from under lock pillar trim and reposition up out of the way.
  8. Pull the carpet from under the instrument panel and accessory trim plate.
  9. Pull the seat electrical connector down through the carpet, if equipped.
  10. Remove the carpet.
  11. Remove the carpet air outlet, if necessary, by turning the air outlet counterclockwise.
About FixVault