FixVault
Home › Pontiac › 2001 › Aztek Base, AWD › Repair and Diagnosis › External Pages › Different car › Section 1287 (Seat System) › Repair Instructions › Trim Panel Replacement - Front Seat › Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Panel Side To Seat Frame
    GM333451Courtesy of GENERAL MOTORS CORP.
  1. Install a new barrel clip (1) to the trim panel upper barrel post (2)
    2. Fig 2: Switch To Side Trim Panel & Screws
    GM281995Courtesy of GENERAL MOTORS CORP.
  2. Install the switch to the panel (if removed).
  3. Connect the switch harness.
    4. Fig 3: Side Trim Panel & Switch Harness
    GM71221Courtesy of GENERAL MOTORS CORP.
  4. Install the seat side trim panel.
    • Push the barrel post with clip through the hole in the seat cover and into the hole in the seat frame.
    • Install the front and rear trim panel attaching screws.
    5. Fig 4: Recliner Handle To Reclining Mechanism Shaft
    GM376637Courtesy of GENERAL MOTORS CORP.
  5. Install the seat back recliner handle. Refer to Seat Back Recliner Handle Replacement - Front .
About FixVault