Installation Procedure
WARNING: This page is about a different car, the 2003 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
- With the RDM secured to a support stand, position the RDM to the vehicle.
- Install the left and right RDM mounting bolts to the mounts.
- Hand install NEW bolts to the left and right mounting bolts.
- Install the RDM rear mounting bracket. Refer to Differential Carrier Assembly Mount Replacement .
- Tighten the left and right RDM mounting nuts.
Tighten: Tighten the nuts to 105 N.m (77 lb ft).
- Position the propeller shaft to the vehicle and support the propeller shaft at the front and rear.
- Install the support bearing to the vehicle.
- Hand install the support bearing bolts.
- Align the reference marks on the propeller shaft CV joint and the PTU output flange.
- Align the reference marks on the propeller shaft flange and the RDM input flange.
- Install the propeller shaft. Refer to Propeller Shaft Replacement in Propeller Shaft.
- Install the rear wheel drive shafts. Refer to Wheel Drive Shaft Replacement - Rear in Wheel Drive Shafts.
- Install the muffler and intermediate pipe assembly. Refer to Muffler Replacement (Service Part) or Muffler Replacement (Production Assembly) in Engine Exhaust.
- Lower the vehicle.
NOTE:
Refer to FASTENER NOTICE
in Cautions and Notices.