Installation Procedure

WARNING: This page is about a different car, the 2007 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.

Ensure the ignition switch is in the ACC position.

NOTE: Refer to Fastener Notice .

Position the ignition switch to housing and install the screws and tighten.
Tighten: Tighten the screws to 2.5 N.m (22 lb in).

Fig 1: View Of Ignition Housing & Multi-Function Bracket

Courtesy of GENERAL MOTORS CORP.

Pre-assemble the lock housing and multifunction lever bracket. Hand tighten the bolts leaving approximately 3.2 mm (0.125 in) gap.
Slide the bracket onto the column. Ensure lock tab fully engages into the column slot.
Hand tighten the lower bolt until snug.
Hand tighten the upper bolt until snug.
Tighten the lower bolt, then the upper bolt.
Tighten: Tighten the bolts to 8 N.m (71 lb in).

Fig 2: View Of Park Lock Cable Assembly & Ignition Module

Courtesy of GENERAL MOTORS CORP.

Snap the ignition lock cable onto the ignition module.

Fig 3: View Of Ignition Housing Electrical Connectors

Courtesy of GENERAL MOTORS CORP.

Connect the ignition housing electrical connectors.

Fig 4: View Of Multifunction Lever

Courtesy of GENERAL MOTORS CORP.

IMPORTANT: Ensure both locking tabs are seated.

Install the multifunction levers.
Install the steering column trim covers. Refer to Steering Column Trim Covers Replacement .
Install the SIR coil. Refer to Inflatable Restraint Steering Wheel Module Coil Replacement .
Install the steering wheel. Refer to Steering Wheel Replacement .
Enable the SIR system. Refer to SIR Disabling and Enabling .
Program the immobilizer system. Refer to Programming Immobilizer System Components .