FixVault
Home › Pontiac › 2001 › Aztek Base, AWD › Repair and Diagnosis › External Pages › Different car › Section 1548 (Wiring Systems And Power Management - Introduction) › Repair Instructions › Ignition Lock Cylinder Replacement › Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Actuator Blade & Ignition Module
GM964632Courtesy of GENERAL MOTORS CORP.
IMPORTANT: Actuator blade within the ignition module must be in ACC position to install the lock cylinder assembly. If rotated, reposition the actuator blade to the ACC position using needle nose pliers.
    Fig 2: Turning Ignition Lock Cylinder To RUN Position
    GM874786Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: If you are installing a new lock cylinder, refer to Key and Lock Cylinder Coding .
  1. Insert key into ignition lock cylinder and install the cylinder into the lock housing.
  2. Rotate the lock cylinder in the housing. Verify proper rotation.
  3. Install the steering column trim covers. Refer to Steering Column Trim Covers Replacement .
  4. Enable the SIR system. Refer to SIR Disabling and Enabling .
  5. Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection (2.2L (L61) and 3.5L (L66)) or Battery Negative Cable Disconnection and Connection (2.4L (LAT)) .
About FixVault