FixVault
Home › Pontiac › 2001 › Aztek Base, AWD › Repair and Diagnosis › External Pages › Different car › Section 643 (Body Rear End) › Repair Instructions › Endgate Replacement › Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2002 GMC Yukon XL, 2002 GMC Yukon, 2002 Chevrolet Tahoe, 2002 Chevrolet Suburban, and 2002 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Support Cable At Mounting Bolt
    GM388060Courtesy of GENERAL MOTORS CORP.
  1. With an assistant, install the endgate onto the left body side hinge by sliding to the left and lifting.
  2. Install the endgate to the right side hinge assembly by holding the endgate at a 45 degree angle and lowering the endgate onto the hinge.
    3. Fig 2: Endgate & Theft Deterrent Bolt
    GM352939Courtesy of GENERAL MOTORS CORP.
  3. Install the cables onto the side panel striker bolts.
    4. NOTE: Refer to FASTENER NOTICE .
  4. Install the theft deterrent bolt.

    Tighten:  Tighten the bolt to 25 N.m (18 lb ft).

  5. Inspect the endgate operation.
About FixVault