Installation Procedure

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2002 GMC Yukon XL, 2002 GMC Yukon, 2002 Chevrolet Tahoe, 2002 Chevrolet Suburban, and 2002 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Linkage Rod & Endgate Handle Assembly

Courtesy of GENERAL MOTORS CORP.

Install the linkage rod to the endgate handle assembly.

Fig 2: Handle Linkage Rods

Courtesy of GENERAL MOTORS CORP.

Engage the linkage rod (1) to the latch assembly.
Install the endgate latch assembly. Refer to Latch Replacement - Endgate .
Raise the endgate.

Fig 3: Endgate Handle Bezel

Courtesy of GENERAL MOTORS CORP.

Install the endgate handle bezel. Pressing into place until fully seated.

Fig 4: Endgate Handle Bolts

Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to FASTENER NOTICE .

Tighten the endgate handle bolts.
Tighten: Tighten the handle bolts to 25 N.m (18 lb ft).