FixVault
Home › Pontiac › 2001 › Aztek Base, AWD › Repair and Diagnosis › External Pages › Different car › Section 647 (Wiper System & Washer System) › Repair Instructions › Wiper Transmission Replacement › Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2002 GMC Yukon XL, 2002 GMC Yukon, 2002 Chevrolet Tahoe, 2002 Chevrolet Suburban, and 2002 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: Refer to FASTENER NOTICE .
    Fig 1: Wiper Motor & Bolts
    GM513716Courtesy of GENERAL MOTORS CORP.
  1. Install the wiper motor onto the wiper transmission assembly with the 2 bolts.

    Tighten:  Tighten the 2 bolts to 8 N.m (71 lb in).

    2. Fig 2: Installing Wiper Transmission To Wiper Motor Crank Arm
    GM306515Courtesy of GENERAL MOTORS CORP.
  2. Install the drive link onto the wiper motor crank arm with the J 39529  .
    3. Fig 3: Wiper Transmission Assembly & Bolts
    GM348543Courtesy of GENERAL MOTORS CORP.
  3. Install the wiper transmission assembly on the vehicle with the 2 bolts.

    Tighten:  Tighten the 2 bolts to 9 N.m (80 lb in).

    4. Fig 4: Wiper Motor Electrical Connector
    GM348725Courtesy of GENERAL MOTORS CORP.
  4. Connect the electrical connector to the wiper motor.
    5. Fig 5: Reinforcement Panel & Bolts
    GM348540Courtesy of GENERAL MOTORS CORP.
  5. Install the reinforcement panel with the 4 bolts.

    Tighten:  Tighten the 4 bolts to 9 N.m (80 lb in).

  6. Install the air inlet grille panel. Refer to AIR INLET GRILLE PANEL REPLACEMENT .
  7. Install the wiper arms. Refer to Wiper Arm Replacement .
  8. Operate the wipers and inspect for proper operation.
About FixVault