FixVault
Home › Pontiac › 2001 › Aztek Base, AWD › Repair and Diagnosis › External Pages › Different car › Section 659 (Power Seat System) › Repair Instructions › Seat Replacement - Front Bucket › Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2002 GMC Yukon XL, 2002 GMC Yukon, 2002 Chevrolet Tahoe, 2002 Chevrolet Suburban, and 2002 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the seat in the vehicle.
  2. Connect the electrical harness, if equipped.
    3. NOTE: Refer to FASTENER NOTICE .
    Fig 1: Front Seat Nut Cover & Seat Retaining Front Nuts - Front Bucket
    GM363709Courtesy of GENERAL MOTORS CORP.
  3. Move the seat to the full forward position in order to install the seat retaining rear bolts (1).

    Tighten:  Tighten the retaining rear bolts to 55 N.m (41 lb ft).

  4. Install the front seat adjuster nut cover (3), if equipped.
  5. Move the seat to the full rearward position and install the seat retaining front nuts (2).

    Tighten:  Tighten the nuts to 55 N.m (41 lb ft).

  6. If equipped with side air bags, enable the SIR system. Refer to ACTIVATING SYSTEM .
About FixVault