Installation Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, 2004 Chevrolet Cab & Chassis Silverado, and 2003 GMC Sierra. However, it is still accessible from the selected car via links, so may be relevant.

Install the brake pedal.
Install the brake pedal bolt.

Fig 1: Installing Brake Pedal Bolt

Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Install the nut to the brake pedal bolt.
Tighten: Hold the nut with a wrench and tighten the brake pedal bolt to 47 N.m (35 lb ft).
Install the pushrod (3) and the stop lamp switch (2) to the brake pedal pin (1).
Install the pushrod retaining clip (4).

Fig 2: View Of Pedal Stud, Stop Lamp Switch, Pushrod & Retaining Clip

Courtesy of GENERAL MOTORS CORP.