FixVault

Test A: Park Lock Solenoid Inoperative

NOTE: For circuit reference, see CONNECTOR IDENTIFICATION  and WIRING DIAGRAMS  .
  1. Did you review SYMPTOM DIAGNOSIS and all the necessary inspections? If so, go to next step. If not, see SYMPTOM DIAGNOSIS  under TROUBLE SHOOTING.
  2. Connect a test light between ground and the park lock solenoid ignition feed circuit (Orange/Black wire). Does the test light illuminate? If so, go to step  4. If not, go to next step.
  3. Inspect for poor connections at the park lock solenoid connector. Did you find and correct the condition? If so, go to step  6. If not, go to step  5.
  4. Repair the short to battery voltage in the park lock solenoid ignition feed circuit (Orange/Black wire). After repairs, go to step  6.
  5. Replace the park lock solenoid (part of shift control assembly). See FLOOR SHIFT CONTROL  under REMOVAL & INSTALLATION. After repairs, go to step  6.
  6. Operate the system in order to verify the repair. Did you find and correct the condition? If so, system is okay. If not, go to step  1.