FixVault
Home › Pontiac › 2001 › Aztek Base, FWD › Repair and Diagnosis › External Pages › Different car › Section 1426 (Power Sun Roof) › Repair Instructions › Sunroof Replacement › Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2002 GMC Yukon XL, 2002 GMC Yukon, 2002 Chevrolet Tahoe, 2002 Chevrolet Suburban, and 2002 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Sunroof Module
    GM582982Courtesy of GENERAL MOTORS CORP.
  1. Install the module to the vehicle.
    2. Fig 2: Tightening Bolts In Sequence
    GM730181Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to FASTENER NOTICE .
  2. Loosely install the 9 bolts retaining the module to the roof.

    Use a drill bit to align the 2 holes A and B.

    Tighten:  Tighten the 9 bolts in the sequence shown to 9 N.m (80 lb in).

  3. Connect the electrical connectors.
  4. Install the drain hoses. Refer to Sunroof Drain Hose Replacement - Front  and Sunroof Drain Hose Replacement - Rear .
  5. Install the headliner. Refer to HEADLINER REPLACEMENT .
  6. Install the finishing lace. Refer to Sunroof Finishing Lace Replacement .
  7. Synchronize the sunroof motor if necessary. Refer to Sunroof Motor Synchronization .
About FixVault