Installation Procedure

WARNING: This page is about a different car, the 2007 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Rear Axle Upper Control Arm, Knuckle Nut & Bolt

Courtesy of GENERAL MOTORS CORP.

Install the upper control arm to the knuckle.
Loosely install the upper control arm to knuckle nut and bolt.

Fig 2: Rear Axle Upper Control Arm, Support Nut & Bolt

Courtesy of GENERAL MOTORS CORP.

Install the upper control to support bolt and cam nut.

NOTE: Refer to Fastener Notice .

Tighten the upper control arm to knuckle nut and bolt.
Tighten: Tighten the bolt to 160 N.m (118 lb ft).
Tighten the upper control arm to support bolt.
Tighten: Tighten the bolt to 160 N.m (118 lb ft).
If applicable, install the ABS harness to the upper control arm.

Fig 3: View Of Trailing Arm Bracket To Body Bolts

Courtesy of GENERAL MOTORS CORP.

Push upward on the trailing arm and loosely install the front bolt.
Use a drift to align the remaining bolts.
Tighten: Tighten the trailing arm bracket to body bolts to 110 N.m (81 lb ft).
Lower the vehicle.
Check the rear alignment. Refer to Measuring Wheel Alignment .