Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of MAP Sensor

Courtesy of GENERAL MOTORS CORP.

Position the MAP sensor to the bracket.
Connect the MAP inlet vacuum hose.
Connect the MAP sensor electrical connector.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Install the screws.
Tighten: Tighten the screws to 3 N.m (27 lb in).