FixVault
Home › Pontiac › 2002 › Aztek AWD › Repair and Diagnosis › External Pages › Different car › Section 1044 (HVAC Systems - Automatic) › Repair Instructions › Blower Motor Control Processor Replacement › Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Blower Control Processor Assembly
    GM295304Courtesy of GENERAL MOTORS CORP.
  1. Install the blower motor control processor assembly to the HVAC module assembly.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the rearward mounting screw.

    Tighten:  Tighten the screw to 1.8 N.m (16 lb in).

  3. Install the forward mounting screws.

    Tighten:  Tighten the screws to 1.8 N.m (16 lb in).

    4. Fig 2: Identifying Electrical Connector From The Blower Motor Control Processor Assembly
    GM295302Courtesy of GENERAL MOTORS CORP.
  4. Connect the electrical connector to the blower control processor assembly.
  5. Install the blower motor to the HVAC module assembly.
  6. Install the blower motor mounting screws.

    Tighten:  Tighten the screws to 1.8 N.m (16 lb in).

    7. Fig 3: Blower Motor & Electrical Connector
    GM295327Courtesy of GENERAL MOTORS CORP.
  7. Connect the blower motor electrical connector.
  8. Install the right side I/P insulator. Refer to Closeout/Insulator Panel Replacement - Right in Instrument Panel, Gages and Console.
About FixVault