FixVault
Home › Pontiac › 2002 › Aztek AWD › Repair and Diagnosis › External Pages › Different car › Section 1044 (HVAC Systems - Automatic) › Repair Instructions › Blower Motor Control Processor Replacement › Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the right side I/P insulator. Refer to Closeout/Insulator Panel Replacement - Right in Instrument Panel, Gages and Console.
    2. Fig 1: Blower Motor & Electrical Connector
    GM295327Courtesy of GENERAL MOTORS CORP.
  2. Disconnect the blower motor electrical connector.
  3. Remove the blower motor mounting screws.
  4. Remove the blower motor from the HVAC module assembly.
    5. Fig 2: Identifying Electrical Connector From The Blower Motor Control Processor Assembly
    GM295302Courtesy of GENERAL MOTORS CORP.
  5. Disconnect the electrical connector from the blower motor control processor assembly.
  6. Remove the forward blower control processor mounting screws.
  7. Remove the rearward blower control processor mounting screw.
    8. Fig 3: View Of Blower Control Processor Assembly
    GM295304Courtesy of GENERAL MOTORS CORP.
  8. Remove the blower control processor assembly from the HVAC module assembly.
About FixVault