FixVault
Home › Pontiac › 2002 › Aztek AWD › Repair and Diagnosis › External Pages › Different car › Section 1053 (Body Front End) › Repair Instructions › Hood Latch Release Handle Replacement › Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the hood release cable to the hood release handle.
    Fig 1: Locating Hood Release Handle
    GM630479Courtesy of GENERAL MOTORS CORP.
  2. Install the hood release handle to the instrument panel.
    Fig 2: Hood Release Handle Base
    GM182644Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Install the bolts to hood release handle base.

    Tighten:  Tighten the hood release handle base bolts to 2 N.m (18 lb in).

  4. Install the knee bolster panel. Refer to Knee Bolster Replacement in Instrument Panel, Gauges, and Console.
  5. Install the left IP Insulator Panel. Refer to Closeout/Insulator Panel Replacement - Left in Instrument Panel, Gauges, and Console.
About FixVault