FixVault
Home › Pontiac › 2002 › Aztek AWD › Repair and Diagnosis › External Pages › Different car › Section 1064 (Front Suspension System) › Repair Instructions › Steering Knuckle Replacement › Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
  2. Remove the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.
  3. Remove the front wheel drive shaft bearing. Refer to Wheel Bearing/Hub Replacement - Front .
  4. Remove the front lower control arm ball stud. Refer to Lower Control Arm Replacement .
  5. Remove the outer tie rod end from the steering knuckle. Refer to Rack and Pinion Outer Tie Rod End Replacement in Power Steering.
  6. Remove the bolt retaining the ABS harness bracket to the steering knuckle.
    7. Fig 1: Scribing Strut To Knuckle
    GM385558Courtesy of GENERAL MOTORS CORP.
  7. Scribe the strut to the knuckle.
    8. Fig 2: View Of Steering Knuckle To Strut Bolts
    GM385564Courtesy of GENERAL MOTORS CORP.
  8. Remove the bolts connecting the strut to the knuckle.
  9. Remove the knuckle from the vehicle.
About FixVault