FixVault
Home › Pontiac › 2002 › Aztek AWD › Repair and Diagnosis › External Pages › Different car › Section 1064 (Front Suspension System) › Repair Instructions › Wheel Bearing/Hub Replacement - Front › Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Wheel Bearing/Hub & Splash Shield
    GM357695Courtesy of GENERAL MOTORS CORP.
  1. Install the wheel bearing/hub.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install NEW wheel bearing/hub bolts.

    Tighten:  Tighten the new wheel bearing/hub bolts to 130 N.m (96 lb ft).

  3. Install the brake rotor. Refer to Brake Rotor Replacement - Front in Disc Brakes.
  4. Install the wheel drive shaft nut. Refer to Wheel Drive Shaft Replacement - Front in Wheel Drive Shafts.
    5. IMPORTANT: Ensure that the connector clip engages the bracket properly.
  5. Install the wheel speed sensor electrical connector to the bracket.
    6. Fig 2: Locating Front Wheel Speed Sensor Electrical Connector
    GM625609Courtesy of GENERAL MOTORS CORP.
  6. Connect the wheel speed sensor electrical connector.
  7. Install the tire and wheel. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.
  8. Lower the vehicle.
About FixVault