FixVault
Home › Pontiac › 2002 › Aztek AWD › Repair and Diagnosis › External Pages › Different car › Section 1090 (Transfer Case - STEYR) › Repair Instructions › Speed Sensor Replacement › Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
  2. Remove the right front tire and wheel. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.
  3. Disconnect the electrical connector from the speed sensor.
    4. Fig 1: View Of Transfer Case Hose/Clamp Assembly, Vent Hose, Bracket & Bolt
    GM630581Courtesy of GENERAL MOTORS CORP.
  4. Remove the speed sensor/vent hose bolt (3) from the transfer case.
  5. Reposition the pinion housing vent hose (2) and mounting bracket away from the speed sensor bolt boss.
    6. Fig 2: Locating Speed Sensor
    GM630579Courtesy of GENERAL MOTORS CORP.
  6. Remove the speed sensor (1).
  7. Remove O-ring from the speed sensor, if necessary. The O-ring may be reused if it is not cut or damaged.
About FixVault