FixVault
Home › Pontiac › 2002 › Aztek AWD › Repair and Diagnosis › External Pages › Different car › Section 1224 (Cruise Control System) › Repair Instructions › Clutch Pedal Cruise Control Release Switch Replacement › Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Clutch Cruise Control Release Switch At Bracket
    GM71495Courtesy of GENERAL MOTORS CORP.
  1. Install the clutch cruise control release switch to the bracket.
  2. Fully seat the switch to the bracket.

    Audible clicks will be heard while pushing the switch.

    3. Fig 2: Clutch Cruise Control Release Switch Electrical Connector
    GM71493Courtesy of GENERAL MOTORS CORP.
  3. Connect the clutch cruise control release switch electrical connector.
    4. Fig 3: Adjusting Clutch Cruise Control Release Switch
    GM73242Courtesy of GENERAL MOTORS CORP.
  4. Adjust the clutch cruise control release switch.
  5. Grasp the clutch pedal and pull fully rearward against the pedal stop.

    Audible clicks may be heard as the switch moves into the adjusted position.

  6. Install the LH I/P lower insulator panel. Refer to Closeout/Insulator Panel Replacement - Left in Instrument Panel, Gages, and Console.
    7. NOTE: Refer to Fastener Notice in Cautions and Notices.
  7. Connect the negative battery cable.

    Tighten:  Tighten the negative battery cable bolt to 15 N.m (11 lb ft).

About FixVault