FixVault
Home › Pontiac › 2002 › Aztek AWD › Repair and Diagnosis › External Pages › Different car › Section 1256 (Wiper System & Washer System) › Repair Instructions › Wiper Motor Replacement › Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Wiper Motor Splash Shield To Wiper Motor
    GM206250Courtesy of GENERAL MOTORS CORP.
  1. Install the wiper motor splash shield onto the wiper motor.
  2. Position the wiper motor to the wiper motor module.
    3. NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Install the wiper motor screws.

    Tighten:  Tighten the screws to 10 N.m (89 lb in).

  4. Install the wiper motor crank arm. Refer to Wiper Motor Crank Arm Replacement .
  5. Install the wiper drive system module. Refer to Wiper Drive System Module Replacement .
  6. Install the air inlet grille panel. Refer to Air Inlet Grille Panel Replacement in Body Front End.
  7. Inspect the wipers for proper operation.
About FixVault