FixVault
Home › Pontiac › 2002 › Aztek AWD › Repair and Diagnosis › External Pages › Different car › Section 1604 (HVAC System - Automatic) › Repair Instructions › Mode Control Cam Replacement › Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2009 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Mode Actuator
    GM1646796Courtesy of GENERAL MOTORS CORP.
  1. Remove the driver knee bolster. Refer to Driver Knee Bolster Replacement .
  2. Remove the communication interface module, if equipped. Refer to Communication Interface Module Replacement .
  3. Disconnect the electrical connector from the mode actuator.
  4. Remove the mode actuator screws from the evaporator case assembly.
  5. Remove the mode actuator from the evaporator case assembly.
    6. Fig 2: View Of Mode Cam Bracket, Mode Cam & Mode Cam Levers
    GM1646798Courtesy of GENERAL MOTORS CORP.
  6. Remove the screws retaining the mode cam bracket (1) to the evaporator case assembly.
  7. Remove the mode cam bracket (1) from the evaporator case assembly.
  8. Remove the mode cam (2) and the mode cam levers (3) from the evaporator case assembly.
About FixVault